Fanggong explains the seven steps of micro electric hoist installation for you:

　　1. Open the box. Be sure to lift the tape paper wrapped around the rope barrel wire rope and take it off before you can test the machine, if you test the machine in a hurry, it may cause the wire rope to roll backwards and break the limit frame.

　　2. Direct contact between the wire rope and the limit frame should be avoided, otherwise it will cause the limit switch to fail, causing the miniature electric hoist to not work normally.

　　3. Do not let the micro electric hoist be rained or soaked in water, the protection level of the micro electric hoist is IP54.

　　4. The body of the miniature electric hoist cannot be moved or rotated along the mounting rod.

　　5. The standard power supply for the miniature electric hoist is a single-phase AC water tent, and a socket with a grounding wire must be used.

　　6. Warning: Make sure that all cables are kept at an appropriate distance from the rotating or heating parts on the miniature electric hoist.

　　7. If the electric hoist is in a non-descending state, the last three-turn wire rope coated with red paint on the electric hoist drum cannot be released. If you continue to press the lowering switch, the wire rope will be wound upside down on the rope barrel, so that the electric hoist will open and lower the operation upside down, so that the limit switch will lose its effect.